Mô tả sản phẩm: LPS STRONG STEEL STICK RENEWAL COMPOSITE
PROPERTIES
Compression Strength (ASTM D695): 8,000 psi (55 MPa)
Color:Dark grey
Density: 18.5 lb/gal., 2.2 gm/cm3
Dielectric Strength: 300 volts/mil
Electrical Resistance: 30,000 megohms
Full Cure Time: 24 hours @ 75°F (24°C)
Hardening Time: 20 minutes @ 75°F (24°C)
Hardness (SHORE, ASTM D1706): 80 D
Lap Shear Tensile Strength on Steel
(1” x 1” x 1/16”): 900 lbs (6.2 MPa)
Shrinkage: <1%
Temperature Resistance: 300 °F (149°C)
Working Time: 4 minutes @ 75°F(24°C)
Upper Temperature Limits
Continuous 250°F (121°C)
Intermittent 300°F (149°C)
DIRECTIONS
Before applying, roughen and clean the area to be repaired. Then follow these steps.
1. CUT or twist off required amount.
2. MIX by kneading with fingers to a uniform color. If mixing is difficult, warm Strong Steel Stick to room temperature or slightly above.
3. APPLY to surface to be repaired within 2 minutes of mixing. Force into any cracks or holes and strike off excess material, preferably with a tool moistened with clean water.
When applying to a damp, wet or slowly leaking area, work the material forcefully into the surface and apply pressure until adhesion begins to take effect.
FOR BEST RESULTS: Use damp fingers for easier mixing, application, and smooth appearance of the cured compound. emove excess material before hardening begins.
Compression Strength (ASTM D695): 8,000 psi (55 MPa)
Color:Dark grey
Density: 18.5 lb/gal., 2.2 gm/cm3
Dielectric Strength: 300 volts/mil
Electrical Resistance: 30,000 megohms
Full Cure Time: 24 hours @ 75°F (24°C)
Hardening Time: 20 minutes @ 75°F (24°C)
Hardness (SHORE, ASTM D1706): 80 D
Lap Shear Tensile Strength on Steel
(1” x 1” x 1/16”): 900 lbs (6.2 MPa)
Shrinkage: <1%
Temperature Resistance: 300 °F (149°C)
Working Time: 4 minutes @ 75°F(24°C)
Upper Temperature Limits
Continuous 250°F (121°C)
Intermittent 300°F (149°C)
DIRECTIONS
Before applying, roughen and clean the area to be repaired. Then follow these steps.
1. CUT or twist off required amount.
2. MIX by kneading with fingers to a uniform color. If mixing is difficult, warm Strong Steel Stick to room temperature or slightly above.
3. APPLY to surface to be repaired within 2 minutes of mixing. Force into any cracks or holes and strike off excess material, preferably with a tool moistened with clean water.
When applying to a damp, wet or slowly leaking area, work the material forcefully into the surface and apply pressure until adhesion begins to take effect.
FOR BEST RESULTS: Use damp fingers for easier mixing, application, and smooth appearance of the cured compound. emove excess material before hardening begins.
|
TEMPERATURE |
WORKING TIME |
HARDENING TIME |
FUNCTIONAL CURE TIME |
FULL CURE TIME |
| 75°F (24°C) | 4 MINUTES | 20 MINUTES | 60 MINUTES | 24 HOURS |
